Raymarine Radar Cable with Raynet Connector, 10m
Quick take
The Raymarine Radar Cable with Raynet Connector, 10m is a digital radar cable designed to connect RayNet-equipped radar antennas to a Raymarine multifunction display. It is a good choice if you specifically need a 10m run and your radar system uses RayNet connectors. The biggest buying caveat is compatibility, so you should confirm your existing radar and display both support the RayNet cable path.
Pros and cons
Pros
- 10m length for flexible routing between radar antenna and display.
- Built for Raymarine radar systems using RayNet connectors (intended connecting cable for HD digital radar antennas).
- Ethernet cable category is Cat 5e, suitable for the intended digital radar connection type.
- Works for indoor or outdoor installations.
Cons
- Limited to Raymarine radar setups that use RayNet connectors, so it may not fit other brands or connector standards.
- Review evidence is limited and mostly focused on ordering and delivery experience rather than long-term installation or performance.
What buyers think
Buyer-review evidence for this specific cable is limited, so it is hard to confirm consistent themes about long-term reliability, signal performance, or installation usability. The reviews available skew positive and include straightforward comments about the order arriving as expected and service being satisfactory, but they do not provide enough product-level detail to draw strong conclusions beyond overall buyer satisfaction with the purchase experience.
What this cable is for
This Raymarine digital radar cable is intended for connecting an HD digital radar antenna with RayNet connectors to a Raymarine multifunction display. If your current setup needs an additional run, a replacement, or a longer cable path for mounting locations, the 10m length is often the deciding factor.
Key specs that matter for installation
Cable type and network category
The cable is categorized as Ethernet Cat 5e, aligning with the digital nature of the radar connection it supports.
Length
At 10m (about 32.8 feet), it is best for installations where the antenna and display are separated by a medium distance. If your route is tighter or you want slack reduction, you might also consider shorter options, while larger boats may require longer runs.
Connector and pinout details
It uses RayNet connectivity and is listed with a 4-pin ATX connector type, with 8 pins mentioned in the product details. Practically, what matters for buyers is that this cable matches the RayNet cable standard used by compatible Raymarine radar systems.
Indoor or outdoor use
The cable is intended for indoor and outdoor installation, which is helpful for typical marine wiring paths where the cable may be routed near exterior mounting areas.
Who should buy it
- You have a Raymarine radar setup that uses RayNet connectors and you need a 10m digital radar cable run between the antenna and display.
- You are replacing a missing or damaged radar cable and want a direct-length match for your installation layout.
- You want a straightforward, purpose-built radar cable rather than adapting mismatched wiring components.
Who should skip it
- If your radar antenna or multifunction display does not use RayNet connectivity, this cable is unlikely to be the right fit.
- If your installation distance is significantly less than 10m and you want to minimize extra cable, you may prefer a shorter length option.
Pros and cons, in plain terms
- Great fit: Raymarine RayNet radar antenna to Raymarine multifunction display cabling where 10m is the right distance.
- Main risk: buying the wrong connector standard for your specific radar and display pairing.
Is it worth it?
For buyers with a compatible Raymarine RayNet radar system, this 10m cable is a practical way to get the right connection type and length in one purchase. If you are unsure about compatibility, the best move is to confirm your radar antenna and multifunction display both support RayNet cabling before ordering, since that is the factor most likely to make the purchase a mismatch.
Price and availability
Pricing and stock can change frequently. Check the latest availability and cost before you order, especially if you are coordinating a complete radar installation or replacement.
FAQ
What Raymarine systems does this radar cable work with?
It is intended for Raymarine radar systems that use RayNet connectors, specifically for connecting HD digital radar antennas to Raymarine multifunction displays that support this connection type.
Is the 10m length enough for most boat installs?
10m is a common “middle distance” length for many setups, but the right choice depends on the physical distance and cable route between your antenna mounting location and your display. Measure your run to ensure you have enough reach without excessive slack.
Can this cable be used outdoors?
Yes, it is listed for indoor and outdoor usage, which suits typical marine routing where the cable may be exposed to exterior conditions.
What cable type is it (Ethernet, Cat rating, etc.)?
It is specified as an Ethernet Cat 5e cable category for the intended digital radar connection.
Are buyers happy with this product?
Available buyer reviews are limited and do not provide a robust pattern on long-term performance, but the feedback shown is generally positive and includes satisfaction with the order and service.
Specifications
| Product Title | Raymarine Radar Cable with Raynet Connector, 10m |
|---|---|
| Category | Electronics > Car & Vehicle Electronics > Marine Electronics > Radar Systems |
| Brand | Raymarine |
| Manufacturer | Raymarine |
| Model Name | Raymarine A80228 10M Digital Radar Cable w/RayNet Connector On One End |
| Color | Black |
| Item Weight | 0.27 Kilograms |
| Connector Type | 4 Pin ATX |
| Cable Type | Ethernet |
| Compatible Devices | Raymarine radar systems |
| Other Special Features of the Product | Not_Performance_Used |
| Compatible Phone Models | No Compatible Phone Models |
| Ethernet Cable Category | Cat 5e |
| Connector Gender | Male-to-Male |
| Number of Pins | 8 |
| Recommended Uses For Product | Connecting HD Digital Radar Antennas with RayNet connectors to a multifunction display |
| Specification Met | RoHS |
| Indoor Outdoor Usage | Indoor, Outdoor |
| Unit Count | 1.0 Count |
| Number of Items | 1 |
| Item Shape | As Shown |
| Brand Name | Raymarine |
| Customer Package Type | Standard Packaging |
| Model | A80228 |
| Item Length | 16 Centimeters |
| UPC | 723193770597 |
| Global Trade Identification Number | 00723193770597 |
Recommended next
AirNav Radar FlightStick VHF
The AirNav Radar FlightStick VHF is a USB VHF airband receiver designed to help you listen to live aviation transmissions (118–136 MHz). It includes an integrated filter, amplifier, and ESD protection, but buyer feedback suggests setup can be demanding on some platforms, so it is best for users who are comfortable troubleshooting software and configurations.
SI-TEX T-760 Compact Color Radar w/4kW 18 Dome (7" Touchscreen Marine Radar)
The SI-TEX T-760 is a compact marine color radar built for small to medium boats, pairing a 4kW 18" dome with touchscreen control and a space-saving helm footprint. It is a strong fit if you want pro-style target detection and tracking in a slim package, but buyer confidence is limited by sparse review evidence.
Raymarine ST4000MK2 Wheel Drive OnlyNot A Complete Pilot
Raymarine ST4000MK2 Wheel Drive is a wheel-drive autopilot motor meant to replace an existing ST4000MK2 drive. It can be a straightforward swap for matching systems, but it is not a complete autopilot kit, so you need the compatible control head and existing installation to make it work. Buyers tend to like the exact-fit replacement experience, while the main drawback is cost versus doing a simple motor-only replacement.
Raymarine Quantum 2 Doppler Radar with 15m Cable (T70417)
Raymarine Quantum 2 Doppler radar with a 15m power and data cable is built for solid-state marine radar performance with features like Doppler collision avoidance, safety sector alerts, MARPA, and target trails. It’s a strong fit if you want Doppler assistance and want the flexibility of either Wi‑Fi or hardwired data connection, but it depends on your existing Raymarine setup for full compatibility.