Cable Matters 200-Pack Nail-in Cable Clips Cord Organizer, 7mm / 0.27 inches, Ethernet Cable Wall Clip, Wire Wall Clips, White
Quick take
This 200-pack of Cable Matters nail-in cable clips is designed to route and hold cables with a 7mm outside diameter or smaller. It works well for snug, fixed cable runs along baseboards, wood trim, and other surfaces where you do not need to maintain pulling tension. The main caveat is that the nail length can be less reliable in drywall compared with wood.
Pros and cons
Pros
- Simple one-piece design, each clip includes an integrated nail (no extra parts to lose).
- Good fit for cables up to 7mm outside diameter, including common coax, Ethernet Cat 5/Cat 6, and small speaker wire runs.
- Large 200-pack helps cover longer installs and future cable tweaks.
- Reviewers report strong holding in wood when installed correctly, and cables stay put once hammered in.
Cons
- Not ideal for keeping tension on cables that need to be pulled tight (some buyers note sags on certain Ethernet types).
- Nail length and grip may be weak in gypsum drywall compared with wood.
- Best results require spacing, light hammering technique, and a pry tool if you ever need to remove clips.
What buyers think
Buyer-review evidence is fairly consistent that these clips are easy to install and hold well when the nail can bite into a solid surface. Multiple buyers describe good grip in wood and a snug cradle for cables that match the 7mm fit. There is also a recurring theme that they are meant for routing, not for maintaining tension on a cable run.
What these cable clips are for
These are nail-in wire wall clips that let you route low-voltage cables neatly along baseboards, wood trim, and other tight paths. They are built for everyday cord management, like keeping a short coax run tidy in a home theater setup, or organizing longer antenna or networking cable lines along walls.
Fit and compatibility (the 7mm rule matters)
The clip is intended for cables with an outside diameter up to 7mm (0.27 inches). That sizing matters because these clips work by cradling the cable in a fixed opening, then anchoring the clip to the wall with a nail. If your cable is thicker than the stated limit, it may not seat properly, which can lead to poor hold or a loose fit.
These clips are designed to accommodate a range of common cable types within the size limit, including coax (such as LMR 240, RG8X, RG58/RG59, RG6) and Ethernet Cat 5/Cat 6, along with 12 to 16 AWG speaker wire and other slim cables. If you are unsure, measure the cable’s outside diameter and compare it to the 7mm spec.
Installation experience: fast, but technique affects hold
Installation is straightforward, since each clip includes a nail. In practice, success tends to come down to three things: spacing, light and controlled hammer strikes, and getting the nail seated cleanly. Several reviewers describe tapping the clips into place as a workable approach, especially on wood, and note that removing them can require a tool because the loop and nail connection can resist hand prying.
If you plan to mount on drywall, be prepared for a potentially less secure bite than you would get in wood, and consider spacing or using a removal-pry tool if adjustments are needed.
Pros and cons in real home terms
Where these clips make sense
- You are routing Ethernet or coax along a wall where you want the cable to stay aligned and out of the way.
- You are organizing speaker wire runs or small device cables behind or alongside baseboards.
- You prefer a permanent, low-fuss anchoring method over adhesives or larger raceway channels.
Where you may want a different approach
- Your installation depends on keeping tension on the cable run, because these clips are primarily for securing placement rather than holding pulled tension.
- You are mounting extensively in drywall, where shorter nails can reduce holding strength. In that situation, you might compare alternatives that are explicitly intended for drywall anchoring.
- You expect frequent changes to the route, since clips can be challenging to remove cleanly once fully seated.
Verdict: should you buy?
Buy these if you want an affordable, straightforward way to route and secure low-voltage cables with an outside diameter of 7mm or less, especially along wood trim or similar solid surfaces. Choose another option if your priority is maintaining cable tension, or if you need strong, consistent anchoring across drywall without concern for nail pull-out.
Price and availability
These 200-pack clips are typically positioned as a budget-friendly bulk option for cable organization. Check the current price and availability before ordering, since multipacks can vary by retailer and time.
FAQ
What cable sizes fit these clips?
They are designed for cables with an outside diameter of 7mm (about 0.27 inches) or smaller.
Will these hold Ethernet cable securely on the wall?
They can hold Ethernet cable securely when the clip is properly installed and the cable fits the 7mm opening. They are best for routing and placement, not for keeping a cable under pulling tension.
Do they work well in drywall?
Performance can be weaker in drywall compared with wood, since the nail is relatively short. Wood installs tend to be the most reliable based on buyer feedback.
Are these clips easy to remove if you make a mistake?
They are designed to stay put once nailed in, which can make removal harder than adhesive-based solutions. If you might need to reposition frequently, plan on using a tool to pry them up.
Do they come with nails included?
Yes. Each clip is a one-piece nail-in style, with an integrated nail, so you do not need extra fasteners.
How many clips do I get?
This pack contains 200 cable clips.
Specifications
| Product Title | Cable Matters 200-Pack Nail-in Cable Clips Cord Organizer, 7mm / 0.27 inches, Ethernet Cable Wall Clip, Wire Wall Clips, White |
|---|---|
| Category | Electronics > Accessories & Supplies > Cord Management > Cable Straps |
| Brand | Cable Matters |
| Manufacturer | Cable Matters |
| Color | white |
| Size | Cable Clips |
| Number of Pieces | 200 |
| Recommended Uses For Product | home theater setup, office, commercial space |
| UPC | 081159816407 |
| Number Of Items | 1 |
| Set Name | 200 |
| Model | 501002 |
| Part Number | 501002 |
| Unit Count | 200.0 Count |
| Fastener Type | Nail |
| Size Name | Cable Clips |
| Outside Diameter | 7 Millimeters |
| Item Diameter | 7 Millimeters |
| Compatible Staple Crown Width | 0.27 Inches |
| Screw Head Style | Simple, functional plastic clip head |
| Compatible Groove Diameter | 7 Millimeters |
Recommended next
Fastening Nylon Strap with Buckle,10Pack Reusable Self-Adhesive Hook and Loop Cable Securing Straps,Adjustable Cinch Straps for Cords Organized and Tidy(1" x 8")
These 10-pack nylon hook-and-loop cable straps with a buckle are designed for quick organizing and re-adjusting of cords, cables, and small bundles. The 1-inch by 8-inch length is most useful for moderate bundles, and choosing the right size is key if you want a tight cinch.
VELCRO Brand Easy Hang Extension Cord Straps (3-Pack, Assorted Sizes)
VELCRO Brand Easy Hang extension cord straps are heavy-duty, hook-and-loop organizers made to keep long, bulky cords tidy in garages, sheds, and RVs. The 3-pack includes assorted strap sizes (10, 14, and 18 inches) and uses a rust-resistant grommet for easy hanging. Best for buyers who want quick wrap and release, but they require wall/peg hooks or nails to use effectively.
ZTSXLLIM Extension Cord Holder Organizer (4 Pack L)
The ZTSXLLIM Extension Cord Holder Organizer (4 Pack L) is a set of heavy-duty nylon storage straps with a triangle buckle for hanging extension cords, power tool cords, and hoses. Buyers like how sturdy the straps feel, how well they keep cords contained, and the practical size for garage and shed organization. The main caveat is that these are designed for bundling and hanging, not for managing cords that need frequent re-routing or quick detaching.
Heavy-Duty Wrap-It Storage Straps, 13-inch (6 Pack)
The Heavy-Duty Wrap-It Storage Straps (13-inch, 6 pack) are hook-and-loop cord organizers designed to wrap and hang extension cords, hoses, rope, and similar gear. With a stainless steel grommet for hanging and a polypropylene strap meant to handle up to 50 lbs, they’re a practical choice for garage, RV, and vehicle storage, as long as your cords and lines fit the 13-inch strap size.